Lectrosonics HMa UHF Plug-On Wireless Transmitter (941.525-959.825 MHz)

$1,625.00 $1,320.00
(You save $305.00)
SKU:
LEC-HMa-941
Availability:
Ships from manufacturer
Shipping:
Calculated at Checkout
Manufacturer Part Number:
HMa-941
  • Lectrosonics HMa UHF Plug-On Wireless Transmitter (941.525 to 959.825 MHz)
  • Lectrosonics HMa UHF Plug-On Wireless Transmitter (941.525 to 959.825 MHz)
  • Lectrosonics HMa UHF Plug-On Wireless Transmitter (941.525 to 959.825 MHz)
  • Lectrosonics HMa UHF Plug-On Wireless Transmitter (941.525 to 959.825 MHz)

What's in the Box

  • Lectrosonics HMa UHF Plug-On Wireless Transmitter (941.525 to 959.825 MHz)
  • PHTRAN3 Leather Pouch
  • 2 x AA Alkaline Batteries
  • Limited 1-Year Warranty

The HMa from Lectrosonics is a UHF plug-on transmitter that accepts mic or line-level signals via a standard XLR connector. It has selectable 5, 15, & 48V phantom power and can be used when paired with a Lectrosonics receiver and handheld microphone - sold separately - in applications for ENG (Electronic News Gathering), EFP (Electronic Field Productions), interviews for broadcast TV, and more.

The input amplifier of the HMa transmitter uses an ultra-low noise op-amp for quiet operation and is gain controlled with a wide range dual envelope limiter. A 24-bit A to D converter digitizes the audio, and filters the supersonic noise above 21 kHz. The resulting signal is encoded with a proprietary algorithm to produce an analog data signal for RF transmission.

Featuring a wide tuning range of 76 MHz, with tuning steps in increments of 100 kHz or 25 kHz for up to 695 frequencies, the HMa transmitter also covers three standard 25.6 MHz Lectrosonics frequency blocks. Each block provides 256 different pilot tone frequencies. Legacy analog wireless microphone and IFB receivers are designed to work in DSP compatibility mode, as well as some receivers from other manufacturers.

Finally, the transmitter is powered by two AA batteries, with status indicated by a multi-color LED. A USB port is also provided for firmware updates, and an IR (infrared) port is included to simplify setup with IR enabled receivers.

Digital Hybrid Wireless is a revolutionary design that combines digital audio with an analog FM radio link to provide outstanding audio quality and the exemplary RF performance of the finest analog wireless systems
Multi-color LED status indicator
Selectable 50/100 mW output power
76 MHz tuning range in 100 kHz or 25 kHz steps for up to 695 frequencies
The antenna is formed between the machined aluminum housing of the transmitter and the attached microphone or cable. It functions as a dipole radiator when attached to a hand-held microphone and somewhat like a ground plane antenna when connected with a cable or plugged directly into a mixer
Frequency Selection Steps Selectable; 100 kHz or 25 kHz
Operating Frequency 941.525 to 959.825 MHzl
RF Power Output Selectable 50/100 mW
Pilot Tone 25 to 32 kHz; 5 kHz deviation (in the Digital Hybrid mode)
Frequency Stability ± 0.002%
Deviation ± 75 kHz (max in Digital Hybrid mode)
Spurious Radiation 60 dB below carrier
Equivalent Input Noise -125 dBV (A-weighted)
Input Level Nominal 2 mV to 300 mV, before limiting; greater than 1V maximum, with limiting
Input Impedance 300 ohms
Limiter Dual envelope "soft" limiter; greater than 30 dB range
Gain Range 55 dB; panel mounted membrane switches
Modulation Dual bi-color LEDs indicate modulation of -20, -10, 0, +10 dB
referenced to full modulation
Frequency Response 35 Hz to 20 kHz (+/-1 dB)
Low Frequency Roll-Off Adjustable for -3 dB @ 30, 50, 70 Hz
THD 0.2% (typ. 100 Hz to 20 kHz)
Signal to Noise Ratio SmartNR Off
no limiting: 103.5 dB
limiting: 108 dB

SmartNR Normal
no limiting: 107 dB
limiting: 111.5 dB

SmartNR Full
no limiting: 108.5 dB
limiting: 113 dB
Dynamic Range 125 dB (with full Tx limiting)
Controls and Indicators Power/Phantom "ON-OFF" switch
Phantom voltage selector switch
Audio input gain knob
LCD w/ membrane switches
LED audio level indicators
Audio Input Jack Standard 3-pin XLR (female)
Phantom Power Off; 5 V @ 18 mA max; 15 V @ 15 mA max; 48 V @ 4 mA max
Antenna Housing and attached microphone form the antenna
Battery Two 1.5 Volt AA lithium or rechargeable NiMH recommended
Battery Life Alkaline
No Phantom: 5 hrs
48 V on: 3.5 hrs
Emission Standard 180KF3E
Dimensions 4.25 x 1.62 x 1.38" / 10.8 x 4.1 x 3.5 cm
Weight 7.5 oz / 211 g with AA batteries
Package Weight 1.15 lb
Box Dimensions (LxWxH) 9.8 x 7.9 x 2.9"